[Archiv] Ako nainstalovat T-PoT v Total Commanderi

[nofly]

Zdravim vim ze to tady asi moc nepatri ale fakt nevim jak dostat tento plugin do Total comander dělal sem to podle tohoto
http://www.youtube.com/watch?v=hF9zyK09PVs jenze problem mam kdyz po tom co mam poklikat na t-pot.wfx tak se mi zobrazi

poradte kde delam chybu

[dodo_mt]

Vyskusaj tento navod

dodo

[Beavers]

Pokud umíš anglicky:

Installation
---------------

1) Normally all you have to do is to open the .zip file with Total Commander
and it will self-install.

* A pop-up will open asking you whether you want to install the plug-in or
not, answer "Yes".

* If another version was installed before, you have to choose whether you
want to overwrite the files or to install the plug-in into another
directory. In the case you install an update or re-install the plug-in,
simply choose to overwrite.

Note that you will be able to overwrite the plug-in even if you have
opened a connection on the iPod. The new version will correctly replace
the previous one and you should be able to go on browsing on the device.

* Otherwise an installation directory is suggested, you may modify it if
you want. Click on OK when you are ready to install the plug-in.

2) If for some reason the self-install doesn't trigger, proceed as follows to
install it manually:

* Copy T-PoT.wfx to the following directory:

<TotalCommander>\plugins\wfx

where "<TotalCommander>" is the Total Commander installation directory,
e.g. c:\Program Files\totalcmd. You may have to create the wfx
subdirectory if it doesn't exist yet.

* In Total Commander, choose "Configurations" / "Options..." from the
menu.

* In the "Configuration" window, select "Plugins", under the "Operation"
category on the left panel.

* Click on the "Configure" button of the "File system plugins (.WFX)"
plug-in category, on the right.

* Click the "Add" button and browse to the directory where you have
copied the T-PoT.wfx file earlier. Select this file and click
on the "Open" button.

3) In both methods a new plug-in will be shown in the "File system plugins"
window.

* The default name that will show in the "Network Neighborhood" system
folder of Total Commander is "T-PoT", but you can rename it by clicking on
"Rename" if you wish. You can also do that later from the configuration
menu.

* Click on "OK" when you are done, to close the "File
system plugins" window, and OK again to close the "Configuration" window.

[nofly]

no anglicky moc neumím to je taky špatny českej návod jste nikde nevideli?
EDIT: super už to mám už to běží mockrát dík

[dodo_mt]

Ok zamykam. Ak by nieco odomknem napis mi PM.

dodo